2
October

Diy: ‘99 Accord Seafoam


Instructional video, like a sea foam & #39; 99 Honda Accord 4-Zylinder

posted under , | Comments (10)

10 Responses to “Diy: ‘99 Accord Seafoam”

  1. valeratj says:

    Do I have to rev it till the smoke goes away or can I leave it idling? Also, how much fuel has to be in the tank?

  2. GreddyAccord99 says:

      rev mà ¼ you ssen, to receive if you terminate you lose much gas in the no-load operation and still nothing can do, the more probably, if good rev them the best from it. They mà ¼ do not ssen much gas into the tank, but use fà ¼ r a full tank have, so that the Gischt in the tank will spread in the whole tank instead of only a few gallons.

  3. valeratj says:

      ? Hundi? yo! ? The?

  4. nusdogg says:

      They könnten tomorrow still do.

  5. Shtoops27 says:

    try a funnel i heard there easier to use when pouring fluid in holes. . . .

  6. 300zx93nismo1 says:

    i have a question plzz reply!so when ur done pouring the seafoam in the vacum hose do u rev the engine a lil bit? and then turn the car off and re do the same process? after the 10-15 min plz help and thank u one last question bout the gas tank part u just continue driving it like that?

  7. GreddyAccord99 says:

      When You& #39; RH done pour simply out and wait you 10-15, then you start revolutions. if it anfängt too brà ¼ llen, like you gieà Ÿ EN finish it the purpose. and, after the Gieà Ÿ EN into the gas tank, drive you always normally.

  8. 300zx93nismo1 says:

    i got this same car as u :) the only difrence mine is a vtech but its auto

  9. GreddyAccord99 says:

    you mean there is no difference because mine is vtec (not vtech) and its automatic. . 

  10. GreddyAccord99 says:

    if you look at 3:42 you can see I have about 1-2 gallons left. shortly after I filled up to spread out the seafoam in the gas tank

Leave a Reply


Powered by Yahoo! Answers