Instructional video, like a sea foam & #39; 99 Honda Accord 4-Zylinder
7
October
Diy: ‘99 Accord Seafoam
posted under Accord, Seafoam | Comments (10)
NaturaRedWeb.com
Green living tips @ the Internet
Green living tips @ the Internet
Instructional video, like a sea foam & #39; 99 Honda Accord 4-Zylinder
posted under Accord, Seafoam | Comments (10)
Powered by Yahoo! Answers
Set by the suction line. It is a line from the firewall to the intake manifold. You can also go through the PCV line, which connects with the intake manifold.
 Hey great video! Only my AGR valve had to replace and to remove the suction tube at carbon from the valves to öffnen. Becomes in any case with some sea foam, if it seems as good as everyone to say. Only a short question. I have 99 Accord a V6, know you that the vacuum line, which should separate? Do you have hren vielfältigen also into the admission fà ¼?
Do I have to rev? It?
rev you need, when you stop losing much gas at idle and still can not do anything, even more likely if good rev you get the best of it. You do not have much gas in the tank, but the benefit for a full tank, so that the foam in the tank will spread throughout the tank instead of just a few gallons.
Sank yo!
Might do this tomorrow.
 try, a funnel, hörte I, to use more simply with the Ausgieà EN of the Flà ¼ ssigkeit into the Löcher. ….
? Have an answer? N the question plzz! ? Acted as ur pouring the seafoam into the vacum hose makes u rev the engine A Lil Bit? ? And then turn off the car and do it again, the same process? ? The? the
when youre done pouring just shut it off and wait 10-15, THEN start revving. if you start revving as soon as you finished pouring it defeats the purpose. and yes, after pouring in the gas tank, continue driving normally.
I have the same car u:) I just difrence VTech, but his car